1, regularly check the parts, monthly, check the worm gear, worm, lubrication block bolts, bearings and other activities of the rotation of the flexible and wear conditions, found that defects should be repaired in time, not reluctantly used.
2, the machine should be placed in the dry and clean indoor use, not in the atmosphere containing acid and other corrosive gases in the body of the use of the site.
3, after the use of the machine or stop, should remove the rotating drum to clean and brush the remaining powder in the bucket, and then installed, for the next use to prepare for the work.
4, when the drum in the work before and after the movement, to adjust the M10 screws to the appropriate position, if the shaft is channeling, the back of the M10 screw to the appropriate position, adjust the clearance to the bearing does not occur, hand-turn pulley, elastic appropriate, too tight or too loose can cause damage to the machine May.
5, the body part of the machine is equipped with oil table, before driving should be all refueling once, midway can be in accordance with the temperature rise of the bearings and the operation of the situation added.
6, the Worm gear box must be long-term storage oil, the oil surface height of the worm gear all intrusion into the oil, if used regularly, every March to change the new oil, going at the bottom of the oil plug, can be put oil.
7, in the machine refueling, do not make oil spill cup outside, do not flow to the machine around and the ground, because the oil is easy to make material pollution, affect product quality.